Chipquik Tack Flux no clean in a 10cc syringe w/plunger & tip - SMD291

Nice. Works as it should. thanks

This stuff is great, will be buying again.

Expensive but a must have.

Ive been doing rework for years without spending top dollar for flux. It will never happen again, this stuff is amazing and makes everything easier. A bit pricy but it makes all the difference in the world.

This stuff is wonderful! ^ Review over. Seriously though this stuff is great to solder with. My only gripe is that when you take the needle like tip off they dont give you anything to put it in.... which can prove to get messy over time. Either have a small plastic cap that covers the needle and it would make a world of difference for storage. Same goes with the plunger itself. They should have a little clip that you can snap the two together so everything stays together. -Nigel

As flux, this stuff works just fine, but Ive found it extremely troublesome to clean up. I usually like having my boards clean, especially if Im going to be handling them. Ive been unable to effectively clean this stuff off completely with either 91% isopropyl alcohol or MG 4140 flux remover, both with or without a fairly stiff brush. After soldering, the residue is either a very sticky goop or just straight rosin. Both are annoyingly hard to clean.

Worked as expeted

Would not be without it

Excellent

As advertized