Evergreen CECOMINOD073162 GE • Genteq 1/3 HP 230 Volt Replacement X-13 Furnace Blower Motor

This was a plug and play replacement for my air handler motor in my 1.5 ton Rheem. Works great! My original motor was hooked to the T5 speed connector so I hooked this up the same and it blows alot harder than my original motor. Not sure if I can move it to the T4 and it will slow it down a little and will work in that mode or is the Inverter set up for the T5 only? It blows really hard. Buy very very happy so far.

Great replacement for my carrier system, but not the best. Quality seems lacking. Where my original and more expensive motor had the shaft perfectly placed in the middle of the hole, this shaft was literally touching a little on one edge of the hole. I was even worried before installed, but everything seemed to work fine. This motor is louder, period. It is ok, but it is louder no doubt. I believe this is mainly due to the fact this motor spins 25x times more per minute vs the original. Also, quality is lacking, so a bit lauder. I also noticed the extra airflow due to the extra rpm, but this hasnt affected the way my AC functions. I have mixed feeling about this, but I guess Ill get used to it. And this is why I wanted you to read, nobody seems to mention these basic and super important points in my opinion. Would I recommend it? Sure! I rather have this vs the original, considering the original costs twice or more. I have never done this before, and I did it successfully, no need to use the included electrical harness. Everything was connected the same vs older motor. So dont be afraid if you never done it, theres always a first time for everything. Edit: Motor still working fine after a couple of weeks. I forgot to mention this motor will stop immediately after your compressor outside stops. Usually your blower motor will run for about a minute, but this one does stop immediately, which I dont like at all. I have a smart ac thermostat, so what I do is to start the blower motor fan before I shut the AC down. That way the blower motor keeps working without stopping. Theres always some residual cold left behind in your coils, so for efficiency is good to run the blower motor, more o less as long the air still blowing cold. Final Edit: Definitely lauder than the original. When youre running the heat it gets even lauder. Blows more air I guess. Made one of my vents vibrate, so I had to do a little fix there. Heating performance is fine but I dont like the noise. Ac cooling performance is definitely worse. Because this motor runs at a higher rpm, it throws things out of place. Humidity levels in the house are quite higher by about 8 to 15 % more. I will still keep it because of the money I originally saved and mostly because I dont feel like doing the work again, but if you are about to buy this, do not! Get the real deal, pay a couple hundred more if you can and you will be way happier.

I bought this motor to replace my Broad Ocean KMSAH014C01 that was making my a/c freeze up in the early morning hours. It was delivered the day after I ordered it, nice speedy delivery. Once I was able to get the old motor out installation was quick and easy. I will tell anyone replacing a motor to make sure you have a 6 flat file to remove the old motor before you begin. The motor came with a harness but it was not necessary. The new motor is so much more quiet than my old one. I am very pleased with my purchase. If anything malfunctions I will update my review.

Replaced the blower motor on ac unit.Easy install,runs quiet and costs much less than original.

Perfect replacement for burned out 10 year old motor at a fraction of the cost. Easy to change if you’re technically inclined, my existing wiring harness plugged right in. My AC hasn’t blown this much air, this strong since I’ve owned this house (of course this is the first day it has been used) I Will update this review if anything changes after a few weeks of running it.

Exact replacement. Very happy

Works great and arrived days early!

Arrived on time and it is working like a charm. Very easy to install. Will be purchasing again when our other one goes.

The motor was not hard to wire but can see it might look hard with all the wires coming out. Your only going to use half the wires

No problem s great motor thank you