Evergreen CECOMINOD073162 GE • Genteq 1/3 HP 230 Volt Replacement X-13 Furnace Blower Motor

Replaced the motor myself about 8 months ago. Still running!

Exactly what I ordered and great deal.

This was a plug and play replacement for my air handler motor in my 1.5 ton Rheem. Works great! My original motor was hooked to the T5 speed connector so I hooked this up the same and it blows alot harder than my original motor. Not sure if I can move it to the T4 and it will slow it down a little and will work in that mode or is the Inverter set up for the T5 only? It blows really hard. Buy very very happy so far.

Motor went it very easily. Wired up no problem. Turned the system on and after the initial calibrating of the motor it worked perfectly. Great motor for the price.

Part arrived on time and was well packed so it arrived in good condition. I was surprised to find a complete set of installation instructions as well as a new wiring harness. These were not listed in the online description of the item. I am a very handy DIYer and found the instructions easy to follow when comparing their diagrams and directions to my own pictures of the wiring (before I removed anything).

Need to look at what hp motor you are replacing since there are multiple ones. Not very much info on warranty or returns but the motor seems to be working great. Plugged it in three weeks ago and been running since.

The motor was not hard to wire but can see it might look hard with all the wires coming out. Your only going to use half the wires

Exact replacement. Very happy

Blower motor on a Bryant Central Air Conditioner Model FB4CNF024T00ACAA went out on a Sunday afternoon. OEM part was $500 and wouldnt be in stock for a week. According to the fact sheet on regalrexnord.com, their Genteq Evergreen EM 6203E was a compatible replacement and was half the price and Prime shipped to my door in 2 days. Took a couple of hours to install, most of that spent battling the belly bands infuriating nut/bolt placement that was almost impossible to loosen or tighten because of how little room there was to fit in the required two wrenches. I basically could move the wrench about 1/64th of an inch before I ran out of space and had to reposition it, all the while banging my knuckles on the rough cut sheet metal edges of the housing. However once in the housing, the rest of the install was a cake walk. The motor comes with a very nice instruction booklet and an extra harness that extends the connections that control the fan speed. This is nice because you may have to play around with which connections to use depending on how the old blower motor was programmed and the harness puts the connections in easy reach instead of having to slide a hand between the motor and the wall of the air handler where space is tight. I just used the same positions as my previous motor used and it worked fine. There is NO programming needed for the Evergreen motor to work, it even auto-senses the correct rotational direction of the shaft the first time it starts up. Sitting in my icy cold room as I type this, I cant think of anything negative to say. As you can see in the picture, the only differences between the OEM motor and the Evergreen is that the shaft is a little longer and the connectors are on the housing rather than extending on a harness but, like I previously mentioned, they do include and extension harness specifically for the speed connectors. Will try and remember to update this review in the Winter when I kick on the heat cause I sure aint gonna test that right now! Oh did I mention I probably saved myself $1,000 bucks doing it myself and got it done a heck of a lot faster!!

Company shipped it out right away that was a plus with me since it was getting hot