Evergreen CECOMINOD073162 GE • Genteq 1/3 HP 230 Volt Replacement X-13 Furnace Blower Motor

Been using this for about a month now with no issues. Same as the original. The speed taps on this unit seem a little different than my old unit, but you can match the one thats closest. No problem.

Arrived quickly, fit perfectly, works like original

I installed this as a replacement for the Carrier OEM ECM motor. There are several things to remember about the installation: The hardest part for me was disconnecting the old motor from the fan wheel. There was significant corrosion on the old motor shaft. I recommend that you sand the corrosion off of the visible part of the old fan motor shaft, then spray PB Blaster on the shaft where it is on the fan wheel. I also put a thin coating of wheel bearing grease on the shaft so that the fan wheel would slide off once it was no longer held in place by corrosion. Once the old motor was removed from the wheel it was a quick installation.

Great replacement for my carrier system, but not the best. Quality seems lacking. Where my original and more expensive motor had the shaft perfectly placed in the middle of the hole, this shaft was literally touching a little on one edge of the hole. I was even worried before installed, but everything seemed to work fine. This motor is louder, period. It is ok, but it is louder no doubt. I believe this is mainly due to the fact this motor spins 25x times more per minute vs the original. Also, quality is lacking, so a bit lauder. I also noticed the extra airflow due to the extra rpm, but this hasnt affected the way my AC functions. I have mixed feeling about this, but I guess Ill get used to it. And this is why I wanted you to read, nobody seems to mention these basic and super important points in my opinion. Would I recommend it? Sure! I rather have this vs the original, considering the original costs twice or more. I have never done this before, and I did it successfully, no need to use the included electrical harness. Everything was connected the same vs older motor. So dont be afraid if you never done it, theres always a first time for everything. Edit: Motor still working fine after a couple of weeks. I forgot to mention this motor will stop immediately after your compressor outside stops. Usually your blower motor will run for about a minute, but this one does stop immediately, which I dont like at all. I have a smart ac thermostat, so what I do is to start the blower motor fan before I shut the AC down. That way the blower motor keeps working without stopping. Theres always some residual cold left behind in your coils, so for efficiency is good to run the blower motor, more o less as long the air still blowing cold. Final Edit: Definitely lauder than the original. When youre running the heat it gets even lauder. Blows more air I guess. Made one of my vents vibrate, so I had to do a little fix there. Heating performance is fine but I dont like the noise. Ac cooling performance is definitely worse. Because this motor runs at a higher rpm, it throws things out of place. Humidity levels in the house are quite higher by about 8 to 15 % more. I will still keep it because of the money I originally saved and mostly because I dont feel like doing the work again, but if you are about to buy this, do not! Get the real deal, pay a couple hundred more if you can and you will be way happier.

Perfect replacement for x13 ECM furnace motor. Easy to install. Work perfectly.

Old X13 motor just stop working properly. When it would come on it would just spin slowly and stop so from looking around I knew it was the module on the back. I decided to order this one after research. This is a simple plug and go. The motor does come with new wiring, but there is no need to mess with that if your using this motor to swap not an X13. Just replace and plug this new one in and you should be all set. When you do turn your ac on the motor will spin forward and backwards as it is programming itself.

Exactly what I ordered and great deal.

Direct replacement- best price, none local at twice the price

No problem s great motor thank you

Replaced the motor myself about 8 months ago. Still running!