KILMAT 50 mil 50 sqft Car Sound Deadening Mat, Butyl Automotive Sound Deadener, Audio Noise Insulation and dampening

Great stuff. Easy to apply and was able to cut easily. Be careful when applying with your hands. I forgot how sharp the foil can get and sliced my finger.

Honestly works better than expected, adheres good once you use the correct roller. For better sound deadening you will want to double it up but 1 box gives you quite a bit. Thanks!

Ive installed in my 87 s10 blazer, made a huge difference from what It had before. Took the vibrations out and did quite down a bit. Which is why i also installed in my 82 c10, I installed with a closed cell foam and i feel this combination worked the best . for a truck with a blown 383 3inch straight thru turn down exhaust set up , it made a big difference. Just recently did half my new silverado , definitely a must if youre doing any audio. Plan on installing closed cell foam also. Also sticks well so far, after you roll it I dont expect it to come back off easily.

Great product definitely helped quite the cabin! Even put some under my hood still need to do the front! (2015 ford focus hatch back)

1993 gmc yukon 2 door interior refresh project. 2 boxes of this product will get you the roof, side panels and 90% of the passenger cabin. Kilmat estimates 130 sqft for this project so they are pretty close. Ill buy another box to finish, then cover it with Noico 315mm closed cell foam sheets. This will be so much quieter and warmer in the Montana winters! Pointers: scrub the surfaces then go over with an alcohol rag then a tack cloth. Make sure its really clean. After laying down a sheet use a roller to really smash this stuff into the seams. No really, go over it again until all the little squares have been smoothed out. If you want, mommas rolling pin will work for the big areas. Next I suggest laying closed cell foam over the top. This will increase the sound deadening and help keep your car comfortable.

The best

The product quantity was more that enough to cover 4 doors on a 2008 Tacoma and still had enough to cover probably another 4, had plenty left over. Did install on a 85° day and they adhere really well. Tried using gloves but its hard, easier if you dont use them. It did leave a light smell of tar for a day or two only. The doors do feel as if they close tighter but didt really notice a great difference in outside backgound noise. Speaker sound does sound better. Definetly not to be used as insulation, they feel hot to the touch as metal does but still do recommend.

Wear gloves. Very sharp edges will cut you.. not may, but will. Easy to work with, very malleable. Not so sure it improves the sound insulation that well, but adequate.

I applied it to my 2020 Ford Edge ST. I had enough to do the whole trunk and all 4 doors with about 20 sheets left over. It works very well and nearly silenced the rattles from the 300w rms going to my JL Audio 10 sub. Works great at a fraction of what the major name brand costs!

The mats were very easy to cut up and install inside the interior of my car. Road noises sound muffled which is very nice and vibrations from the subwoofers have less rattle which adds thump and tonality to the music. This stuff is really great and idk if it’s just me but I love the smell of the adhesive, it made installing this very pleasant :)