Seaworthy Innovations Stern Pad - Standard Size - White - Screwless Transducer/Acc. Mounting Kit (not for Large 3D Scan Transducers) - Made in The USA with Genuine 3M VHB Adhesive

Mounted really easy. Just follow the directions and you’ll be fine. It’s been 3 months of use and it’s holding tight.

Super easy and super sticky

Didn’t want to drill 4 holes in the brow of the boat to place the hailing speaker, worked great!

Sticks very well if you clean the area your going to stick it to. Haven’t had any issues on my Carolina skiff with a solix msi + transducer.

My boats name is Betty. I glued this to Bettys stern, and I didnt have to screw her stern to get it on.

I used this to avoid drilling holes in the inside stern of my Boston Whaler to mount a water fuel separator. So far so good but I have not had to put a 25 pound pull against the surface when loosening the canister. Guess I’ll find out about this time next year.

Installed pretty easy and worked fine for a few trips outs. 3rd time was the charm, heard a crack and looked back to see my transducer laying inside the boat. Screws still installed and a chunk of the white pad still attached. The adhesive held find but why would you make the block actually weaker than the adhesive?? Looks like it pulled a plug out of the block screws and all still tight and holding to the plug...

Super easy to install, great product!!

This item is great in concept but not so much an application. This device failed 5 minutes off the boat ramp on its first application. Unfortunately the transducer that was attached ended up in the prop of the boat and was also lost. I followed the prep and installation instructions to a T Amazon customer service was great, not sure I would trust this product.

Adheres great and without the worry of drilling into the transom of your boat.