Seaworthy Innovations Stern Pad - Standard Size - White - Screwless Transducer/Acc. Mounting Kit (not for Large 3D Scan Transducers) - Made in The USA with Genuine 3M VHB Adhesive

No drilling in hull, worked great for mounting my transducer!!!

Used product previously to mount a Transducer, works very well

Peel it and stick it on. Holds well so far. Magical.

Sticks very well if you clean the area your going to stick it to. Haven’t had any issues on my Carolina skiff with a solix msi + transducer.

didnt stick. Fell off after a week. Never in water. Maybe I didnt apply correctly but I followed directions.

Photos make it seem like its rubber, its wood. BUT, works well.

Installed pretty easy and worked fine for a few trips outs. 3rd time was the charm, heard a crack and looked back to see my transducer laying inside the boat. Screws still installed and a chunk of the white pad still attached. The adhesive held find but why would you make the block actually weaker than the adhesive?? Looks like it pulled a plug out of the block screws and all still tight and holding to the plug...

Follow the well-written directions and your results will be as advertised. My application was smooth and the mounted pad was rock-solid after following the instructions and awaiting the prescribed drying time. No issues with this product at all. I would purchase this brand again for sure.

Great to use without drilling holes in your transom!

I followed all the directions, took extra time to let everything get set, mind you I haven’t fished yet. This morning I went to get the boat cover off the boat and the pad was on the floor! Did not work