











5 Inch Dia 8 Hole Sander Hook and Loop Replacement Sanding Pad For Makita BO5010, BO5030/K, BO5031K, BO5041K, XOB01Z Sander
-
Richard Perry
> 24 hourworked good
-
Chris Bloom
> 24 hourPerfect fit for porter cable sander
-
USMC ret
> 24 hourThe product is exactly what I expected, and the shipping response was outstanding.
-
Tyrell Von
> 24 hourThis is a piece of crap. The holes in the pad dont align properly with the tapped holes in the bottom of the sander. Dont buy this. Im returning it.
-
Julie A. Twomey
> 24 hourI got this to replace the current sanding pad on a Makita rotary sander. The pad backing is made of cheap plastic and it lasted about 3 uses before the plastic wore down and the screws were no longer securing it to the unit. My takeaway? Pay a little more for a better replacement.
-
Nick
> 24 hourWasnt a prefect fit but got it to work.
-
Derivativemusic
> 24 hourWhat the headline says. How difficult is it to get something this simple right? If I sound ornery, its because I am. The thing screws onto the sander through three holes. It should take half a minute. Except the holes are too small to accommodate the washers on the screws from the original Makita pad, and I couldnt get the washers off for the life of me. And of course the hardware store was closed when I got there to buy replacement screws and washers. Other than that this pad seems absolutely fine. Sanding discs stick to it, and Im looking forward to finishing the project I expected to finish today.
-
Sam08
> 24 hourScrew holes are off. DONT BUY for Makita BO5010
-
Fatmansworkshop
> 24 hourBreathed new life int my old friend....(makita) Fit well and was a 3.5 minute replacement....easy as pie... The hook pads stay on great.... I highly recommend this replacement part
-
Jeff Topping
> 24 hourCheap and exactly what I needed!