Chipquik Tack Flux no clean in a 10cc syringe w/plunger & tip - SMD291

Not to familiar with flux but this flux does its job quite nicely. Makes desoldering, reflowing, and wicking a breeze. Only complaint is that it takes quite a bit of effort to squeeze out of the bottle but other than that it’s an excellent product.

Must have for all kinds of electronics rework

my go to flux.

This flux works well for both leaded and lead-free solders. Only minor complaint is that with a small tip, 28g or 30g, the required pressure to dispense the flux can cause the flux to leak back past the rubber seal of the plunger. This will not happen with the supplied (much larger diameter) tips. I had to use a 30g needle to apply the flux to a single tiny pad. Im not looking forward to pulling the plunger, cleaning it off, and stuffing the perfectly good leaked flux back into the syringe. So far, the flux hasnt leaked back past the end of the open end of the syringe. Hopefully, repacking the syringe wont be as messy as it sounds.

good stuff

A la perfección

Love chipquik no clean flux

Worked perfectly

Awesome flux. Has saved me countless time with SMD parts and smaller pads. Not too tacky (won’t necessarily hold parts down), but will require rubbing alcohol to clean up. Doesn’t seem to interfere with circuits at all, but gets very sticky and kinda annoying after heating (91% iso alcohol and lint free wipes will take care of that though).

Nice. Works as it should. thanks