













COMOWARE Hole Saw Kit for Wood- 16 Pieces 3/4’’-5’’ Full Set in Case with 1pcs Hex Key, 2pcs Mandrels and 1pcs Install Plate for PVC Board Plastic Plate Drilling Drywall and Soft Wood
-
Jackie M
> 3 dayThese are OK for occasional use, but I wouldnt get them if you need a hole saw often... kind of flimsy.
-
Anuradha
> 3 dayVFM for light DIY usage
-
DeLong
> 3 dayNot a good buy for any practical utility. May be ok for thin plastic. The drill bit had trouble getting through a 1.5 inch pine board. I used a 7/32 drill bit to pre drill. The 1+1/2 inch hole blade wasnt very sharp. The saw dust wasnt being ejected out, despite pulling it out every 1/8 inch or so. I ran my drill at half speed and paused every 30 seconds (hoping not to build up too much heat). I thought maybe I wasnt spinning fast enough to get the sawdust out of the teeth so I speed it up. The wood started smoking (of course) so I stopped. When I ran the drill in reverse (slowly) to pull out the hole saw, the drill bit broke (see pictures). Also, the depth of the saw is a hair shy of an inch (so getting through a 2x4 takes two passes). Just thought Id iterate that here because it didnt help my frustration (I fully take responsibility) . Reading it and experiencing it are two different things.
-
david cuddeback
> 3 dayHad to cut new hole for dryer vent. Worked great
-
Hannah Riezenman
> 3 dayJust received this item yesterday and so far so good. The hardest part is removing the wood from the saw without taking everything apart. If there are any issues I will update my review.
-
Tony Bowles
> 3 dayI needed a new set up hole saws, so I pick up this kit, and it has what I needed, but the drill bit broke after making 5 holes! Other than that its been nice. None of my other drill bits have the flat spot on them for the set screw to work correctly, so Im gonna keep looking for a replacement drill bit.
-
tjl
> 3 dayThis requires a heavy duty drill to attach to. It cuts a nice clean circle that requires very little sanding. Our small drill battery drained fairly quickly on a 1/2 board. This was a good buy. We priced one at a local farm supply store three times the cost.
-
sfhil
Greater than one weekI was working with a pine board and the saw struggled to cut the hole. Great price, but only for use on very soft materials.
-
Greg Neville
> 3 dayEven with soft pine, I had a hard time using this product. Spend the extra money and get the real stuff
-
Jon p.
> 3 dayProduct works great. Only issue I had was the hole is not deep enough to go through 2x4 studs. It seemed to bottom out before it could go all the way through