COMOWARE Hole Saw Kit for Wood- 16 Pieces 3/4’’-5’’ Full Set in Case with 1pcs Hex Key, 2pcs Mandrels and 1pcs Install Plate for PVC Board Plastic Plate Drilling Drywall and Soft Wood

I really liked this product mainly for the price and effectiveness until I went to use it today and it broke off half way through some plywood. It’s good for small projects but when using thicker wood I would recommend going with higher quality sets.

Liked the colors. But disappointed that the safety caps didn’t fit to pop on.

This is a light duty kit. Will cut through sheetrock, soft wood, thin wood over and over again. Anything heavier will wear it down at the fastening hole. Will only cut heavier woods twice before giving out. If you get more than two hd cuts... your doing good. Ok kit for light dulty use

The product worked well for drilling through vinyl siding and wood...nice clean hole.

I bought this because it was recommended by the instructor of a woodworking course that I purchased online. The first time I used it, I was using the 3 hole saw to saw some holes through some 3/4 cherry. I could tell by how it was cutting that it was garbage. I only needed 4 holes for my project, and on the 3rd one, the center of the bit ovaled out so that the auger piece could no longer grab it. These are thin Chinese garbage metal. Maybe its fine if youre drilling through thin pine boards, but I wouldnt recommend this for much else. Spend a little more and buy a quality product is my advice!

I was bit skeptical before using it on 1 inch HT plywood, but the saw worked perfectly. It is a good product for any kind of light to medium wood job, including drywall, carbon fiber and plywood sheets. This saw set is good for domestic projects only, but cant take professional grade job. Overall great product to have in your kitty would recommend it.

Dislike first use the piglet bit bent. Hole saw 3 in dulled after cutting 11 holes in 3/4 red cedar. I would not buy again cheep Chinese quality.

I needed a hole saw to make corn hole tables and this one was very inexpensive than most. It was a little difficult to put together, but it worked.

Good value

I wanted to make a drawer holder for the coffee pods for our new Keurig coffee maker, so I purchased this hole saw kit. It worked perfectly with a hand held cordless drill, would have been even better in a drill press, but I got the job done. Now that I have this kit, I will probably find other uses for it.