Meconard 6 Pack 4 Inch 5CCT LED Recessed Lighting with Night Light, 2700K/3000K/3500K/4000K/5000K Selectable Ultra-Thin LED Recessed Ceiling Lights, 9W=75W, 750LM, Dimmable Canless Wafer Downlight

Before I go into my review, if you do not know what you are doing or not comfortable doing any kind of electrical work, seek out a licensed electrician to help you install these lights! With that said, I absolutely love these thin recessed LED’s. They are so simple to install, simply cut a hole and pop in the light/junction box and the spring clips hold the light tight against the sheet rock. They provide an incredible quality of light in the room, and they are bright! You don’t need a ton of them to evenly light a room. You can also change the color temperature of them to your liking from a more yellow to blueish hue. I prefer pure white. I think it’s the most complementing color temperature to a room since it doesn’t cast a colored hue on everything. The night light feature is awesome! It casts an orange glow from the edges of the lights across the ceiling. Really awesome effect for setting the mood. I would for sure recommend these lights. You can’t go wrong with recessed LED Trims especially with the night light feature!

These recessed lighting has a very cool feature of the Halo night light effect. The nightlight has a warm color and is the ring is well placed so that it does not hurt your eye. The halo light can be turned on by using the power switch and is very easy to control. The main LED lighting is very bright and is dimmable with a dimmer switch and works well to brighten up the entire room. What I like: 1. Cool halo light effect 2. 5 color temperature to choose from 3. Easy installation No notable concern at time of writing.

I ordered the 12-pack of these. I’m installing them in bedrooms. Placing them about two feet out in each corner gives bright, even lighting. It seems counterintuitive, but placing these around the perimeter of a room works better than placing them in the middle. The ETL certification is listed on ETL’s search site. I don’t understand the wet location claim as these lights are not sealed. They are IC rated for direct contact with insulation. I tested them against other LED lights and the color temperature appears accurate. A sampling of three lights all drew 10 watts each. The CRI isn’t listed. They look to be around 80 when comparing them to CRI 95 lamps shining on red oak floors. Ok for bedrooms but if you need accurate color rendering, big box and lighting stores carry CRI 95+, at a much higher price. The junction box is solid enough, and the lights themselves are better made than most of these cheaper varieties.

I chose these disk-style ceiling lights to put in closets and alcoves that are always too dark. They are very easy to install and work well. One thing I like about these 4-inch lights is that they perfectly fit in place of round ceiling wiring box when updating older fixtures. I have replaced several of my “dome” style ceiling lights with these. All I had to do was remove the old fixture and wiring box, wire in the power supply box, and these disks fit perfectly in the hole left by the old fixture. I prefer a warm white lighting in most areas, so I set them to the 3000K color temperature and that is perfect. For bathrooms, I prefer a whiter light so I can set them to the 5000K temperature. These are great, modern looking ceiling lights and I highly recommend them.

If you want to add recessed lighting to a room that doesnt already have the fixtures set up, we found these to be a very good choice. Probably one of the coolest features that it has is the accent mode, which offers the bare minimum illumination but looks really cool with the other lights off in the room. Plus youre not restricted to a single warmth level of lighting. You can choose the temperature so that you dont have a cold pale light, but rather something warm and inviting for your room. Great set at a surprisingly good price.

The lights dim very smooth and I did not see any flickering. We are going to be installing these in our living room once we get to that point in the renovation so I hope they hold up long term. They were packaged very nicely and the press in wire nuts inside the box seemed to be quality and hold things tight. They also use a standard 3pin low voltage lighting connector if you need to extend the distance to the control box without running more conduit or ROMEX.

I have gutted a house and have been replacing the ceilings and adding a lot of downlights to both brighten rooms during the short winter days and to highlight different parts of the rooms or to set moods. To do all of that, I made a test bench where I could easily swap out different light switches and LED downlights. Not all switches work with all LED lights and not all LED lights are dimmable. Some downlights make buzzing noises when you try to dim them, others just switch off and others wont dim less than 90% of full brightness. And different switch / LED downlight combinations can achieve different results. These lights by Meconard claim to be dimmable from 3% to 100%. They are not. They maybe go down to 50% if I am being generous and depending on the switch. Some dimmers result in the light turning off if you set the switch too low. Some switches resulted in buzzing from the LED lights, but the buzzing is very soft. I would doubt most people would notice a few feet from the light. The nightlight is also dimmable and it does dim a bit more than the main light, but not to 3%. Switching between the nightlight and the regular light is done by flicking the wall switch and this feature works well. The light comes with the standard metal box where you make your connections. Opening the box to make your connections is easy enough. The light includes quick connects. The wires from the box are tinned and the wires are rigid enough to be able to push in and out of the quick connects unlike stranded copper. You can choose from several different light temperatures which works well. The switch is on the outside of the metal box so you will have to reach up into the ceiling to change the temperature, but this is normal an having the switch on the outside of the box is preferable. Overall, these are nice lights. I do wish they dimmed as much as claimed but they don’t so I am taking off stars for that. Pros: - easily switch between the light and the nightlight - five different color temperatures - come with quick connects and the light is easy to connect and to install, assuming your wiring is all ready to go on your end. - low profile Cons - not as dimmable as claimed and they can buzz with some dimming switches

So these lights fade down really well and they were super easy to install and connect.. The only thing that I would really suggest is that they supply more than one template just in case you lose or cut your current template.. but thats not really the end of the world Wires were top-notch in the housing seem to be made great and didnt leave any burrs after I knocked out the knockout piece.. quick wearing connectors make it easy for everybody to do the job and really secure the wire in place inside the housing.. these are a great value for the money and I really enjoyed putting these up again stress-free if I hit a stud or ceiling truss..

I used a couple of these to replace a fluorescent fixture in our walk in closet. The lights are bright and much better color. Install was relatively easy after you get past the hesitancy to cut into the ceiling. I only wish there were a way to adjust the color of the light while it is installed, that function is on the power supply which gets installed above the ceiling next to the light fixture.

I would recommend these. They seem to be identical to the ones you buy in the box stores. Can light hardware has come a long way from actually having to install housings and layout out based on the joists above. These haev the segregated junction box and the light itself fits in the space of the drywall. This version of a can light will cost you north of $20 a light in the box stores. They seem to be bright and dont have a flicker. Only time will tell regarding durability.