Micro Swiss Bowden Dual Gear Extruder Compatible with Creality Ender, CR10, CR-10 Pro, CR-10S, CR6-SE, Tornado

Does a great job and easy to install the instructions are really straightforward did have to calibrat my steps after install but worth every penny.

When I was well in practice of using our new printer I had a lot of frustrating issues. The items and upgrades were brand new so I figured it was me and gave up for a long while. Gave up and purchased this and it solved everything. Now I can smoothly switch filament in the middle of a print with no issues!!

The Idea to use a brass crush ring to hold the boden tube in was a bad one. It works well but these tubes wear out and with no spares and No instructions on the Size of the crush connector to buy more Youre in for a world of Hurt if you ever have a issue with your Boden tube. The extruder works alright Doesnt seem worth the price It is High quality but I havent noticed a Huge difference between this and a cheap aluminum duel gear.

Easy swap for the titan-style extruders on my printers. No more noise, no more skipping

I bought this to replace the OEM extruder on my Anycubic Vyper. I highly recommend this upgrade. I have it pared with a Dragon hot end and it has improved the quality of my prints immensely.

Under 300 hrs on it so far but its running great

Its more expensive than the alternatives, but the quality is worth it by far. Id buy this again, and the customer service is great so no worries there! Also, it does not have the extrusion issues that the cheaper ones have, no extrusion inconsistencies.

This thing is made like a swiss watch. I have zero complaints about the item, or packaging or installation. I never got consistent output with this no matter the temp or tension or speed. I tried and tried and really wanted to use this. I have been printing almost non stop for maybe 5 years. I have tried pretty much any filament and extruder you can imagine but I could not get this to work. After days of trial and lots of errors I ended up pulling it and installing one of the $14 MK8 red dual gear extruders. Immediately, the mk8 did a 14 hour print flawlessly. The microwiss just didnt seem to grab the pla, petg or nylon filament as well. I dont want to totally dog it. It has a good reputation and is made VERY well. Just didnt work for me.

High quality, the only small thing is that the bowden tube is a little hard to install and slips every once in a while.

This went on my cr10 smart. Came from an all metal creality and so far its been a night and day difference. Beautiful machining and the fit was perfect. 130 esteps were recommended I ended up at 139. The recommended retraction settings were spot on for my petg. I was only able to run 30mm a second before with the creality extruder before stripping filament but now I can run 45 and that made all the difference. One thing I didnt care for is they recommend to bevel the bowden tube and it was extremely tough to get it aligned/clocked correctly. I ended up just cutting it smooth and running it right up to the end of the exit tunnel and it feeds through fine. I suspect this will make tpu prints much easier as well so Im excited to try them. Definitely a great upgrade that I wish Id bought in place of the creality.