Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q

This is nice tool but it failed after very little use. The problem is that the cutter is installed upside down so it was running backwards. I didn’t realize the issue until after it overheated and one of the carbide cutters came off.

Didnt make it 3 feet down the board before the blades broke off.

Worked as advertised

Unfortunately, this cutter has a poor design and burns before it cuts, even at shallow passes. This one warped after the first use. Get the BOSCH 85526M 1/16 In. Carbide Tipped 3-Wing Slotting Cutter Bit instead.

The Yonico Router Bits Slotting Cutter broke within seconds of using it. Just as other reviewers have stated, the teeth immediately broke off. This could potentially be very dangerous. I would not recommend this product.

Product is as advertised. Works great in my router table . Sharp out of the box. Would recommend this product.

routed groove to install edging on melemine faced particle board

Don’t be fooled by the cheap price and the Yellow DeWalt Tools look. As simply as I can put this....a piece of junk. Purchased this to replace my previous dull router blade, which cost $35 new. This $14.95 Blade burnt out on first pass into pine(!). Immediately took it off and put my dull blade back on. Lesson? Don’t cheap out when purchasing router blades.

I used this on medium speed on oak to make 6 large cabinet doors..uniform cuts to the end..no burning or tear out in the cut or by the roller bearing.

It’s fine, just a little bulky of a bit