



Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q
-
Don Dorn Jr
> 3 dayworked perfectly !!
-
Sera G.
05-06-2025Nice construction and very clean slot cutting. Used it to make slots for installing polycarbonate glass into an indoor French windows.
-
Patrick T.
> 3 dayMade a nice clean cut even through cedar.
-
brian
> 3 dayUsed it to slot in pine boards for plywood panels. It did the job well.
-
Ralph
> 3 dayBetter than expected thank you very much
-
A. Arrick
> 3 dayUnfortunately, this cutter has a poor design and burns before it cuts, even at shallow passes. This one warped after the first use. Get the BOSCH 85526M 1/16 In. Carbide Tipped 3-Wing Slotting Cutter Bit instead.
-
Marc Brrrrrrr
> 3 dayMade a little stand for my van center console/ arcade, used this to cut the channel for the t moulding. It worked. Seemed like it held up just fine
-
jmark
Greater than one weekI needed to cut a dado around a 19 x 36” piece of Baltic Burch. Turned my Bosch corded router down to about 1/3 speed, and tried to make 2 shallow passes as opposed to one deep one. It accomplished 50% of the job with no problem. Barely made it through the last half. Was ready for the trash when finished. World have bought a Diablo, but figured I would never need to perform this application again, and for 1/3 the price,…