



Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q
-
David H.
> 3 dayAs previous reviews it is crap overheated and warped first pass 18 inch board. In the trash now.
-
Linda Branch
> 3 dayMade good and did the job. Very pleased
-
richard page
09-06-2025Using cutter for rail and stile dado cuts for raised panel doors
-
Jesse
> 3 dayrouted groove to install edging on melemine faced particle board
-
Charger
> 3 dayHave not used it but is a very well made bit I think it will work fine & accuracy & durability to be very good, as most products from company are.
-
Carpenter
Greater than one weekI bought that slotting cutter bit to make custom grooves in square-edge composite boards with a small hand router. It works perfectly for the purpose.
-
Mary Kratz
> 3 dayPerfect
-
Augustus W. Smith
> 3 dayGood product.
-
Randi Goodwin
> 3 dayThe second time I used this bit the 2 teeth flew off half way through cutting a channel in a pine door slab. One inbeded in the wall in front of me, the other shattered the customers window behind me. The only bright side was I didnt end up in the ER getting shrapnel removed from my gut! A few inches to the left and this would go from a bad review to a personal injury lawsuit. This item should be immediately removed from Amazon or any other retailer . Someone is going to get seriously injured or killed by this router bit.
-
eric barteldt
> 3 dayReasonable price - used to groove composite decking for clips - made two passes