Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q

BIT WORKED OUT PERFECTLY

I thought I was getting a good deal on this bit, review seemed fine. I used this bit once, for a total of 10 minutes. First the paint coating melted, then the metal holding the carbide blades began to warp. Thank god I was wearing safety glasses, because 10 seconds after it started warping, one of the carbide blades flew off and hit my glasses. Never buying this brand again. Will update with a picture when I get back home.

No issues with it. Cuts a very accurate groove with ease. Bit is very well machined and put together. I probably wont use it enough to wear it out but I am impressed enough that Im going to try some of their other bits that I use more often. Recommended.

Cut/router just over sixteen feet of redwood for my project. it’s accurate and barely notice any wear, even the yellow paint still on the bit. no burning.

This bit couldn’t cut 4’ of particle board melamine from Home Depot…

I used this on medium speed on oak to make 6 large cabinet doors..uniform cuts to the end..no burning or tear out in the cut or by the roller bearing.

Burnt out and warped after less than 24

The bit works just as described!

This is nice tool but it failed after very little use. The problem is that the cutter is installed upside down so it was running backwards. I didn’t realize the issue until after it overheated and one of the carbide cutters came off.

Poor quality