Moen 1200 One-Handle Kitchen and Bathroom Faucet Cartridge Replacement, Brass

Update: A few days later...After using the 1200 caetrage, o have noticed that if you want to reduce the water pressure by pushing it in some (with it connected to the Moen shower knob) it starts to make a very loud sound that radiates through the metal pipes. The original caetrage did not do this, as id often use about half the water pressure while washing and then would increase it when rinsing, and the original caetrage was quite regardless of how much water you adjusted it to by pulling or pushing it in. But this all brass 1200 makes a lot of noise unless you have it pulled all the way out with no water being restricted. Once you start to push it in some to reduce the water pressure, the sound gets louder and louder. I was thinking that its because the brass of the cartridge is vibrating against the metal valve assembly. So I decided to try the 1225 model cartridge since the outside is plastic. Today I took out the brass 1200 and put in the plastic 1225. That right there solved the problem. Now I can use it and like before and push it in to reduce the water pressure without any resistance noise coming from it or the pipes. So Ill be using the 1225 instead. Just have to see how long it will last. Originally review: The main headache is having to use a cartridge remover to remove the old one. Mine was Ori from when this house was built in 1986, and over the past year its been harder to turn the shower water knob and now it wont entire turn off (water still comes out some). So I had to replace the cartridge. I went with the 1200 model since it was all brass and not any plastic like the 1225. After I got the original one out, it actually had some plastic on it, though it was never replaced. The new 1200 all brass one looked much better quality. Got it installed and tested it out. Now you can adjust the temp knob with one finger it moves so easily. I just hope it last almost 37 years like the original.

Better then original plastic flow control.Use plumbing lube when installing.

Moen original equipment, and the best.

Good deal

Remove old one with plastic didn’t work

I received a genuine Moen cartridge (Moen etched into the metal) and it works perfectly. Tried two other knock-offs first and they both leaked.

Fit perfect and was very easy to install

This is a perfect fit. I was afraid I was going to have to do some major plumbing being that the original was fairly old. This part fit exact, and the brass and stainless steel work far better than the old one. Very happy customer.

I replaced this easily enough but within a month it failed and started leaking again, stiff to open and close, etc.. Still fresh in my memory, lets have a look. I went to pull out packing and only the inner stainless shaft came out, the outer brass valve stayed inside housing. The spring steel (outer) C-clip failed. Fortunately Im only out the $25 I paid for this Chinese Moen knock off. Also check your review, whoever monitors this likes to change your 1 star rating 5 stars.

Arrived on time in good packaging. Product is as described and works just fine.