I picked up a set of VR cable management wires similar to these several months back and wound up hardly ever using them because the loops that support the cables were too loose and they slid along the wires. While playing, the cords would always wind up bunched together in one spot, effectively eliminating the usefulness of having them supported from above and causing sagging wires to get in my way while playing. These have a rubberized loop to grip the cables that virtually eliminates the sliding. I cannot even believe how much of a difference that small thing makes! Playing active games with a full 360 degree rotation is tons more fun when you arent worried about getting tangled up in wires. Honestly, these were well worth the few extra dollars in cost over some similar products.

This is an amazing and cheap product. Ive messed around with wireless adapters but theres always issues with heavy batteries, disconnects, extreme expense, etc. This product is amazing though. It only took me about 5 minutes to set up and after playing with the length of the cable, I can barely feel any sort of tug unless I get right to the edge of my play area. Flat ceilings work best but theres a solution for popcorn ceilings as well. Theres no way I can go back or even consider a $300 adapter after trying this.

Works great, easy setup.

Works exactly as intended, when you’re immersed the game you won’t feel it a single bit. However if you consciously think about it it will be noticeable but not very intrusive. I wish there could be tension adjustment which would make every issue with it stop. If you’re sitting down you’ll probably feel it the most but standing up and playing your game is perfectly fine, you won’t notice it a single bit and you’ll be glad afterwards there’s no cable in your way.

I watched a video on YT just to make sure my assumptions were correct about how to mount these, and they were very easy to stick to my ceiling and fasten the cable to the pulleys. Taking the pulleys to off the hooks is quick and easy if I need to store the system. Just an all-around great design.

I get tangled up in the cord anymore which is a huge plus. But you need to be careful if you physically turn a lot. It will twist the headset cord at the top really badly if you dont keep an eye on it. Also you will need to take the headset off most of the time to properly untwist it which can be a bit inconvenient if your in the middle of something. Also it takes a bit of time to get used to sense it pulls upwards on the headset senses its being suspended above your head. You will also need to spend a bit of time adjusting the cord to make it feel comfortable on your head.

I think Ive said this about all the Kiwi products Ive purchased.. GAME CHANGER. Silent operation, At least 7 feet of pull with minimal resistance until you get to the last 2 feet. You know when youre about to run out of slack, but it doesnt interfere with the game. I can tell these people have played a lot of VR and know what is needed.

Easy to install and easy to use. I have been pleased with this product so far.

After using PCVR without this for 2 years, I can still feel the cord on my back. Now I can actually turn around and dance without worrying.

Ultra quiet easy to use. The only thing I would have wish it included was an ability to increase or decrease how strong the cable retraction was. Other than that it is perfect. Yes I know you can increase the length of the cable extension. But I feel it would have been easier to just increase or decrease the tension on the spring.