[Pro Version] KIWI design VR Cable Management, 6 Packs VR Pulley System fits Quest/Rift S/Valve Index/HTC Vive/Vive Pro/HP Reverb G2/PSVR/PS VR2 VR Accessories, Compatible with Quest 2 Link Cable

This has changed the way I experience VR. I used to have to constantly worry about where my tail was, I had to make sure I wasnt stepping on it or spinning around too much, but now, I dont notice or even have to think about the cable while Im playing games. The difference is absolutely astounding. The product quality is good, I have not run into any issues. Be CAREFUL when and where you stick the adhesive hooks, I ripped off a chunk of my ceiling because the adhesive is so strong. I would suggest getting command strip hooks instead.

works great no sound and the straps hold the wire better than any other Ive tried I had older kiwi models around 20$ or less and they were metal loud and broke after a month or so of use these I can say are well worth the use to a true gamer who spends a lot of time using his/her VR setup and likes being freed from wires if you never had a pulley system this is the right one to pick and an easy recommend to any VR user not using a pulley system or are using a loud metal one.

Worked perfectly for cable management for my new Playstation psvr2. Easy to put up...used the screws instead of the adhesive pads. I first used command strips to make sure of my placement and a quick change out to a more permanent installation.

Great product, had it for a few years. The hooks that screw in the wall are great! the pulleys are quiet and have lasted me years. However... I just tried the the adhesive hooks for the first time, and found out I placed them wrong so I tries to change them. That was a bad idea. This kit is good for the pulleys and screw hooks. Do not use the adhesive hook sunless you want to move your wall inside the house.

Genuinely an excellent product. In terms of install, very easy and the only took you need is provided (little hex key). I used the sticky ceiling mounts and theyre very sturdy. Always great to avoid drilling holes. This product makes me wonder how I ever used a wired headset without it. Aside from removing the wire as a tripping hazard, it allows me to hardly notice the cable at all. Couldnt be more pleased and Ill be recommending this product to any of my friends playing PCVR games

I think Ive said this about all the Kiwi products Ive purchased.. GAME CHANGER. Silent operation, At least 7 feet of pull with minimal resistance until you get to the last 2 feet. You know when youre about to run out of slack, but it doesnt interfere with the game. I can tell these people have played a lot of VR and know what is needed.

This is an excellent thing to purchase if you have a VR kit of any sort and dont fancy the idea of tripping over the cable that they typically come with - itll keep it over your head so you can do whatever without tripping over the cable. 10/10, hope I dont have to buy again - but if these break I know where to get em.

These pulleys run smoothly, are quiet, and seem to be built quite well. My medium sized complaint is that, due to the fact you cannot adjust the tension lower, the link to the headset tugs a bit too much. Im sure in a higher ceiling room with more cable to hang down itd work fine, but Id rather a few low tension ones be included in the box (or make the tension adjustable). Ive moderately fixed this problem by attaching a small weight to the last link, but this only works when pulling the headset downward. Tip for those reading: If you loop a rubber band around your VR cable, and a magnetic detachable keychain, you can easily detach and reattach your cable to these pulleys. Picture attached.

I watched a video on YT just to make sure my assumptions were correct about how to mount these, and they were very easy to stick to my ceiling and fasten the cable to the pulleys. Taking the pulleys to off the hooks is quick and easy if I need to store the system. Just an all-around great design.

This functions great as a product to keep cable weight off ones self, but if you are a more ambitious VR enthusiast these are recommended with caution. I have a standard ceiling and I had a handstand go wrong with my foot getting caught in the line. All would have been fine but the length of the system does not reach the floor and caused a mishap with landing. The cable management broke and I have a damaged foot. Also the pull of the cables is on the weaker side and I would recommend about 9 if you want a taut system.