Permatex 22058 Dielectric Tune-Up Grease, 3 oz. Tube

(1072 reviews)

Price
$8.49

Size
Quantity
(40000 available )

Total Price
Share
315 Ratings
256
48
8
1
2
Reviews
  • MikeRock

    > 3 day

    Needed some dielectric grease. This was a big tube compared to the Honda tube I’m replacing for nearly the same cost. Will buy again

  • BigDirty

    > 3 day

    It works great. Used it to lube the stabs on my keyboard and it did the job fine. Still have plenty left over. You could probably do like 50 keyboards with this little tube

  • Big Weave

    > 3 day

    A much better buy than the small packets of bulb grease or spark plug boot grease--an entire tube to keep on hand for any case where dielectric grease is needed without the premium price! Permatex is my go-to for automotive sealants/greases/etc.

  • Connor B

    Greater than one week

    Bought this for tuning my keyboard stabilizer Opening on the tube is the perfect size for inserting stabilizer wire ends!

  • todd wild

    20-11-2024

    I use this tuff at work on batteries and wanted to have the stuff for home use on light connections on the stern light on a boat to keep out the moisture.

  • Ron Kolecki

    > 3 day

    another must have in your garage

  • AP

    > 3 day

    works.

  • Burl 72

    > 3 day

    A needed item when its tune-up time

  • New Zoo Review

    Greater than one week

    Good viscosity for electrical contacts. Easy to spread but not too watery. Similar to Vaseline in consistency. Smooth and consistent. It stays where you put it. Clear. Waterproof. I put it on my Toyota 4Runner master door switch (drivers side), and it stopped the arcing which was causing carbon buildup on the driver window switch contacts. I cleaned the contacts and applied this grease. I hope it will delay the need to buy a new switch from Toyota for $230-$330 for may years.

  • Scott Hartley

    Greater than one week

    Great Dielectric grease for electrical connections. Just the right thickness so it wont run off but still flows nicely. I bought this can over a typical tube because I thought it might be easier to store cleanly and be ready to use when needed. Not really the case, since the applicator tip stores next to the cap and is full of grease. I dont understand why, with just a little more thought, a more sanitary applicator setup could be provided with these grease products. I ended up designing my own tip applicator and made one with my 3D printer that works perfectly and remains on the tip at all times and stores under the factory cap. Now Im really happy with my new grease! Maybe these guys will do something like this for the rest of you some day.

Related products

Shop
( 1793 reviews )
Top Selling Products