









Moen R8712P 12-Inch Bathroom Grab Bar, Peened
-
Gray Guy Handyman
> 3 dayInstalled just outside of a walk in shower. To give a bit of stability on both entrance and exit Good match to grab bars already in the shower
-
shane
> 3 dayExcellent grab bar. Perfect for safety going in and out of the bathtub. A must for everyone to have in their bathroom. I highly recommend it
-
Judith Richards
> 3 dayEasy to install but is hard to tighten up to keep from wobbling. User may find it unsteady.
-
AMZN REVIEWER
> 3 dayInstalled 2 different sizes and these look and work great. Recommend Hilti anchors w/white plastic pull tabs available at home depot for sturdy install when you dont have stud directly behind.
-
ZZLo
> 3 dayConsidering the statistics stating that one of the major causes of injuries at home is slipping and falling in the shower or tub, I thought this was a wise move before I fell prey to this. I have a deeper soaking tub thats also a shower, and therefore the risks getting in and out are greater than average. It was ordered through Amazons web-site and the reason I chose it was because it was the cheapest of all the products in this category, in a brass finish. It arrived within 3 days of the order, and was packaged well. The grab bars covers over the mount were a bit difficult to remove, and needed a screwdriver to prise off. Youve got to do it carefully so as not to mar the finish, but the finish seemed pretty tough anyway. The mount provides multiple positions to position screws. It recommends that you use three screws each, but its kind of hard to find enough room on a 2 stud to put two screws side-by-side, especially when you have to first accurately locate the studs position using a sensor. This is probably the hardest part in trying to mount this on the tiled wall adjacent to the shower / tub. Otherwise, everything else went easily - just be careful drilling through tilework so as not to crack it. I used a hammer drill with a 3/8 bit, but first I covered the drill spot with a piece of electrical tape on which I marked the hole positions. Then go slow... After screwing in the bar, it was easy to slip the brass covers over the mounting plates.
-
JILL PAUL
> 3 dayLove this grab bar - put it in the bathtub/shower & is very sturdy.
-
Pat Granite
Greater than one weekGood looking and sturdy.
-
Jim
> 3 dayItem is white, or, more accurately, off-white. I have a glacier bar . . . does not match
-
Don W. Jordan
> 3 dayThis thing is a beast. Installed it near stairs to my garage and it is awesome.
-
Skier
> 3 dayMoen R8718PS grab bars installed easily, look great. Installed one at entry to tub at an angle, one at rear of tub horizontally, but should have ordered a third to install vertically at left side of shower wall for complete safe use of tub.